Filter
Top Products
ENGLISH / A-9
FORM NO. 56041634 - Advolution™ 2710 / UHR 70-1700 - A-9
INSTALLATION OF THE BURNISHING PAD
WARNING!
Disconnect the machines Battery Pack Connection (7) by pulling up on the Emergency Power Disconnect (10) handle, when ever
servicing the machine.
CAUTION!
Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels.
1 See Figure 2. Grab hold of the right side of the Pad Drive Deck (1) and lift up until it Latches (16) in place as shown.
2 Place your hand underneath the Dust Control Shroud (2) and remove the Pad Retainer (4) from the fl exible pad holder assembly. NOTE:
Grip the retainer fi rmly and turn clockwise (to the right) as the retainer uses a Left Hand thread.
3 Select a 27 inch (68 cm) Dia. Burnishing Pad (AA). See your local Nilfi sk-Advance Distributor for a complete selection of pads and
accessories.
4 Insert the plastic Pad Retainer (4) into the center of the Pad (AA). Then reinstall by turning the retainer counter-clockwise (to the left).
NOTE: Important !!! Turn the retainer in until you hear a clicking ratchet sound, this insures proper tightening of the pad by properly
compressing the pad material and drawing up the retainer so it will not strike the fl oor.
FIGURE 2