Filter
Top Products
NEUTON EM 5.1 Cordless Electric Mower Safety & Operating Instructions 33
Chapter 7: Maintaining and Storing Your
NEUTON Mower
This chapter explains how to clean your Mower; change, sharpen, and balance blades; and store
your Mower for the long-term.
Cleaning Your Mower
Periodically clean your Mower to ensure peak performance.
Supplies needed:
• Clean, damp cloth or sponge
• Mild soap or detergent (if needed)
• Soft nylon brush (if needed)
1. Remove the safety key and battery.
2. Using a damp cloth or sponge with a mild soap or detergent, clean the Mower. Never use
water, gasoline, solvents, or other petroleum-based or solvent-based products when cleaning —
remember, this is an electric mower.
3. Use a soft nylon brush or non-metallic scrubbing pad to remove any clippings that have
accumulated on the underside of the deck and in the rear discharge plate. Do not use a wire
brush; it will scratch and harm the surface of your Mower.
4. You may use water to clean the rear bagger, but not the Mower itself. For proper grass
collection, make sure the grass bag is clean and the mesh holes are not clogged. Allow the Rear
Bagger to dry thoroughly before using it again.
Note: A wet Rear Bagger will clog quickly and hamper grass collection.
Removing and Attaching the Blade
You must remove the blade to sharpen it, or to change to a different blade.
Always check the blade for sharpness, damage, and tightness before and after each use. Replace the
blade promptly if it has been bent or damaged.
Tools & supplies needed:
• 36 mm wrench (supplied with Mower)
• ¾ inch socket or adjustable wrench
• Gloves or rag to protect your hands
Wear heavy gloves to protect your hands when removing and attaching blades.
1. Remove the safety key and the battery. If you are charging the battery, first disconnect the
charger from the electrical (wall) outlet.
2. While holding the handlebars (as if you are mowing), turn the Mower over on its right side to
expose the blade.
3. Place the 36 mm wrench over the steel hex adapter holding the blade (the large metal piece that
holds the blade in position).
WARNING! ALWAYS remove the safety key and battery before performing any
adjustments, maintenance, blade change, or repairs to your Mower.