Filter
Top Products
NEUTON EM 5.1 Cordless Electric Mower Safety & Operating Instructions 15
with the holes in the lower handlebar sections.
3. The handlebars have three height adjustments
(three holes in the upper handlebars). Connect the
handlebars at the height that is most comfortable
for you.
4. Slide the connector bolts (from inside to outside)
through the holes in the upper and lower handlebar
sections on each side of the Mower. Screw on the
black connector knobs, then hand-tighten them just
enough to hold the upper and lower handlebar
sections together on each side.
5. Swing the upper handlebar assembly into an
upright position. The bars will line up and slide into
place (Figure 8). Hand-tighten the black connector
knobs until they are snug.
6. Check the length of the handlebars for comfort. If
necessary, reconnect the handlebars (up or down)
to a height that is best for you.
To save space for storage, you can loosen these black
connector knobs to drop the upper handlebar assembly forward onto the Mower’s deck.
Step 6: Attach the Cable to the Handlebar Assembly
1. Run the cable through the cord clip (Figure 9) on the right lower handlebar section.
2. Align the half-moon cutout on the cable end (Figure 10) with the cable housing on the
handlebars, and slide together. 3. Hand-tighten the locking nut to connect the cable
(Figure 11)
Figure 9. Cord clip on the lower right
handlebar
Figure 10. The half-moon
cut-out on the cable end
Figure 11. Hand-tighten the
locking nut
Figure 8. Align the upper and lower
handlebars and hand-tighten the black
connector knobs