Filter
Top Products
10
F041303L
– 1 –
INSTALL THE DEPTH REGULATOR
LEVER
1. Install the depth regulator lever through hole in bracket
from the bottom up with curve to rear of unit and
secure with detent pin.
FILL ENGINE CRANKCASE
1. Add oil according to engine manual. Do not overfill.
Use a clean, high quality detergent oil. Container must
be marked A.P.I. Service SF - SJ. Use no special
additives with recommended oils. Do not mix oil with
gasoline. Oil level must be full. Check the oil level by
removing the dipstick. Oil level should be at FULL line
on dipstick.
2. Always check oil level before starting engine. Refer to
engine manual for capacity and type of oil to use.
depth
regulator
lever
Engine is shipped from factory without oil. You
must add engine oil before starting engine.
UNPACKING AND ASSEMBLY
Figure 5
detent pin