Filter
Top Products
IMPORTANT
3
F-031061C
SAFE OPERATION PRACTICES FOR WALK–BEHIND SNOW BLOWER
DO NOT OPERATE THIS EQUIPMENT BEFORE READING THIS MANUAL
Read entire owner’s manual before attempting to assemble
or operate this Snowthrower.
Before Operation
S Read and understand this manual. Become familiar with the
Snowthrower and all its controls.
S Exercise caution to avoid slipping or falling, especially when
operating in reverse.
S Know how to stop quickly.
S KEEP CHILDREN AWAY – Keep bystanders a safe distance
from work area.
S Never allow children to operate the Snowthrower. Never allow
adults to operate the equipment without proper instruction.
S Remove mats, boards, sticks, wire or any foreign objects
which can be picked up and thrown by the Snowthrower. Do
not use on gravel surface.
S Do not wear lose clothing or jewelry. They could be caught in
moving parts.
S Do not operate the equipment without wearing adequate
winter outer garments. Wear footwear which will improve your
footing on slippery surfaces.
S Wear rubber boots that don’t leak when operating the
Snowthrower.
S WARNING: TO PREVENT ELECTRICAL SHOCK use only
with an extension cord suitable for outdoor use and in usable
condition. Extension cords are available at your local service
center.
S Inspect the Snowthrower. If any part is damaged, have it
inspected by your local Service dealer before operating.
S Make sure impeller will spin freely before attaching to power
source.
S If impeller will not rotate freely due to frozen ice, thaw unit
thoroughly before attempting to operate under power.
S Use only with a receptacle that has been installed in
accordance with local inspection authorities and wired for
110/120V, 10/20 AMP outdoor service.
S DO NOT USE OVERLOADED CIRCUIT.
S Maintain Snowthrower with care. Follow instructions contained
in this manual.
S Never attempt to make adjustments while the motor is running
(except where specifically recommended by manufacturer).
S To prevent disconnection of Snowthrower from extension cord
during operation follow the instructions for securing the
extension cord contained in this manual.
S Keep bystanders away from the area of operation.
S Avoid accidental starting. Don’t carry plugged in Snowthrower
with finger on switch. Be sure switch is off when plugging in.
S If Snowthrower is to be left unattended, remove key and
disconnect from power source.
S If extension cord is damaged in any way while plugged in –
pull extension cord from wall receptacle. Replace damaged
cord immediately
S WARNING: DON’T ABUSE CORD – never carry Snowthrower
by cord or yank cord to disconnect from receptacle. Keep cord
from heat, oil and sharp edges.
S Keep hands and feet away from moving parts. Keep clear of
discharge opening at all times.
S Don’t force Snowthrower. It will perform better and safer at the
rate for which it was designed.
S Don’t overreach. Keep proper footing at all times.
S If Snowthrower strikes a foreign object:
a. Stop immediately
b. Disconnect from power source.
c. Inspect for damage.
d. Repair any damage before restarting.
S Operate Snowthrower only in adequate light – never in the
dark.
S Never direct snow discharge chute toward glass enclosures,
automobiles, or bystanders. Keep children and pets away.
S Never discharge snow onto public roads or near moving traffic.
S Never attempt using the Snowthrower on a roof.
S Never operate the Snowthrower near window wells, drop–offs,
etc.
S Always be sure of your footing, and keep a firm hold on the
handle.
S Walk, never run.
S Disconnect power cord and remove key whenever you leave
the operating position, before cleaning, or maintaining
Snowthrower.
Preparing for Storage
S Remove residue ice or snow from impeller by briefly running
motor out of snow.
S Disconnect from power source and remove key.
S Store Snowthrower indoors, in dry, locked place, out of reach
of children.
Observe Caution Decals Located On Motor
Housing.
S The use of any other accessory or attachment might increase
the risk of injury to the user.
S When servicing use only genuine factory replacement parts
and accessories.
S For safe operation in snow use only CONTINUOUS power
cords without cuts or cracks in insulation and without taped
splices or mechanical plugs that could seep moisture.
This safety alert symbol identifies important safety messages on machines and in manu-
als. When you see it, be alert to the possibility of personal injuries or damage to unit. Fol-
low all instructions in these safety messages.