Filter
Top Products
PAGE 14 — MQ PS4030 SAW • OPERATION MANUAL — REV. #0 (02/29/08)
■
Examine blade flanges for damage and excessive wear.
■
Ensure the cleanliness of the blade before blade is installed.
Blade should fit snugly on the shaft and against the inside/
outside blade flanges.
■
Ensure the blade is marked with an operating speed greater
than the spindle speed of the saw.
■
Only cut the material that is specified for the diamond blade.
Read the specifications of the diamond blade to ensure the
proper tool has been matched to the material being cut. The
saw has been engineered for WET CUTTING. Ensure a
WET CUTTING blade is being used and that the water supply
system to the blade is properly functioning and being used.
■
ALWAYS keep blade guards in place. Exposure of the
diamond blade must not exceed 180 degrees.
■
Ensure that the diamond blade does not come into contact
with the ground or surface during transportation. DO NOT
drop the diamond blade on ground or surface.
■
The engine governor is set to permit maximum engine speed
in a no-load condition. Do not tamper with the engine
governor to increase the speed. Increasing the engine speed
could allow the maximum rated spindle speed to be
exceeded, creating an unsafe condition.
■
Ensure that the blade is mounted for proper operating
direction.
■
Adhere to the Blade Manufacturer's recommendations on
handling, storage, and safe usage of blades.
Diamond Blade Safety
■
Use appropriate steel-centered diamond blades
manufactured for particular use on your saw. See further
blade information in this manual.
ALWAYS inspect diamond blades
before each use. The blade should
exhibit no cracks, dings, or flaws in
the steel centered core and/or rim.
Center (arbor) hole must be
undamaged and true.
WARNINGWARNING
WARNINGWARNING
WARNING
■
Always observe all applicable compulsory regulations
relevant to environmental protection, especially fuel storage,
the handling of hazardous substances, and the wearing of
protective clothing and equipment. Instruct the user as
necessary, or, as the user, request this information and
training.
MQ PS4030 SAW — RULES FOR SAFE OPERATION
■
DON'T POLLUTE! Waste Oils and other chemicals must be
disposed of in a manner consistent with local and state
environmental protection regulations.
■
Always store equipment properly when not being used.
Equipment should be stored in a clean, dry location out of
the reach of children. When storing the saw in freezing
weather, blow out the water lines to prevent damage to
components in the water delivery system.