Filter
Top Products
PAGE 6 — MOONLIGHT LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #0 (10/27/06)
MOONLIGHT LIGHTING SYSTEM — RULES FOR SAFE OPERATION
The DANGER items listed below and on the next page are
considered
High DANGER
areas and should be adhered
to. Failing to understand these areas could result in
Bodily
Harm, Electrical
Shock
,
Electrocution
, and even
Death!
Please pay close attention when operating the
MOONLIGHT.
DANGER - MOONLIGHT High Danger Areas
TRANSPORTING
■
When transporting the MOONLIGHT over rough terrain,
remove the lamp and pack it safely so it will not be
damaged.
LAMP SAFETY AND CARE
■
NEVER leave any grease or oil residue on lamp surface
when replacing or removing lamp. This can create hot
spots, reducing the service life of the lamp.
■
ALWAYS make sure the lamp surface is clean and dry.
■
ALWAYS replace with MQ recommended type lamp. See
parts section of this manual.
■
NEVER use force when installing a lamp. Excessive force
could cause the lamp to break causing bodily harm.
■
ALWAYS make sure the balloon support assembly is
secure and the knob tightened.
■
NEVER attempt to replace lamp with the power on. Always
unplug the power cord when changing the lamp.
■
NEVER unplug the lamp's AC power cable during
operation.
■
ALWAYS allow a sufficient amount of time for the lamp to
cool
before changing. The possibility exists of severe
burns.
■
ALWAYS have a
trained technician
install and remove
lamp, or replace any damaged fixture wiring.
■
To prevent the balloon from deformation, NEVER use
MOONLIGHT in strong winds.
■
DO NOT place the balloon inside storage case until the
lamp has had a sufficient amount of time to cool down.
■
ALWAYS place the balloon inside its storage case after
each use. This will prolong the life of the balloon material,
keeping it protected from harsh environmental elements.
■
DO NOT use a damaged balloon. Replace balloon
immediately if damaged. In addition, a damaged balloon
will not inflate properly.
■
ALWAYS keep the balloon away from sharp objects and
excessive amounts of heat (
fire!
).
ALWAYS make sure that the mounting pole, cart, stand
or tripod is properly secured to prevent tipping! Use
sandbags or stakes to secure the mounting accessory
as necessary.
DANGER - Mounting Accessory Tipping