Filter
Top Products
1. Loosen the lower T-handle by turning handle
counterclockwise (Figure 20). Push down on mast
until mast is fully inserted into mast housing. Tighten
T-handle fully.
Figure 20. Lowering the Mast
2. Unzip the zipper on the protective cover (Figure 20),
and pull down cover over balloon/lamp assembly.
Figure 21. Unzipping the Protective Cover
3. Unhook lamp AC power cable from washer eyelet
(Figure 14). Fully zip protective cover and fold velcro
tab in place (Figure 22).
LOWER
T-HANDLE
ZIPPER
PROTECTIVE
COVER
OPERATION (GB12BW)
Figure 22. Zipping the Protective Cover
4. Loosen upper T-handle by turning counterclockwise
and lift lamp assembly from mast.
5. Store lamp assembly enclosed with its protective
cover (Figure 23) in a safe location where it will not
be damaged.
Figure 23. Storing Lamp Assembly
6. To retract tripod legs (Figure 24) and place in the
stow position, lift up on mast while pulling up on the
velcro strap. Continue pulling upward on the mast until
the tripod legs are fully retracted and are in the stow
position.
Figure 24. Retracting Tripod Legs
VELCRO
TAB
AC-POWER
CABLE
PROTECTIVE
COVER
PROTECTIVE
COVER
LATCH
UPPER
LOWER
MAST