Filter
Top Products
SETUP (GB12BW)
1. Place balloon assembly (Figure 11) onto mast and
tighten Upper T-handle.
Figure 11. Light Asembly Placement
2. Expose the balloon by pulling down on the velcro tab
and unzip the protective cover as shown in Figure 12.
Also remove the AC power cord at this time.
Figure 12. Removing Balloon/AC Power Cord
MAST
UPPER
T-HANDLE
PROTECTIVE
COVER
LOWER
T-HANDLE
VELCRO
TAB
3. Next, fold the protective cover (Figure 13) into itself
and zip.
Figure 13. Folding Protective Cover
4. Attach the S-type hook (Figure 14) on the AC power
cable onto the washer-eylet located on the bottom plate
of the light assembly.
Figure 14. Securing Power Cord
ZIPPER
PROTECTIVE
COVER
S-TYPE
HOOK
WASHER
EYELET
BOTTOM
PLATE