Filter
Top Products
GA-4.5R/GA-4.5RA A.C. GENERATOR — OPERATION & PARTS MANUAL — REV. #1 (11/27/06) — PAGE 21
General Inspection Prior to Operation
Ground Power Tools
When using power tools or electrical equipment requireing AC
power from the generator, make sure connecting (power tool)
cable has a ground pin as shown in Figure 5.
Extension Cable
When electric power is to be provided to various tools or loads at
some distance from the generator, extension cords are normally
used. Cables should be sized to allow for distance in length and
amperage so that the voltage drop between the generator and
point of use (load) is held to a minimum. Use the cable selection
chart (Table 3) as a guide for selecting proper cable size.
Main Circuit Breaker
To protect the generator from an overload always place the main
circuit breaker in the "OFF" position prior to starting the engine.
Figure 5. Ground Cables/Plugs
NOTE
Never!
use power tools or
equipment that do not have a
ground capability, the possibility
exists
of electrocution
,
electrical
shock or burn
, which can cause
severe bodily harm
or even
DEATH!
GA-4.5R/GA-4.5RA — PRE-INSPECTION
)noitarepOesahPelgniS,zH06(noitceleSelbaC.3elbaT
nitnerruC
serepmA
sttaWnIdaoLhtgneLelbaCelbawollAmumixaM
stloV021tAeriW01#eriW21#eriW41#eriW61#
5.2003.tf0001.tf0
06.tf573.tf052
5006.tf005.tf003.tf002.tf521
5.7009.tf053.tf002.tf521.tf001
010021.tf052.tf051.tf001
510081.tf051.tf001.tf56
020
042.tf521.tf57.tf05
.egatlovwolmorftlusernacegamadtnempiuqE:NOITUAC