Multiquip DCA-25USIXF Portable Generator User Manual


 
DCA-25USIXF/DCA-25USI2XF — OPERATION AND PARTS MANUAL — REV. #1 (05/08/09) — PAGE 21
1
DCA-25USIXF/DCA-25USI2XF— ENGINE OPERATING PANEL
The definitions below describe the controls and functions of
the "
Engine Operating Panel
" (Figure 7).
1. Panel Light - Normally used in dark places or at night.
When activated, panel will luminate. When the generator
is not in use, turn the panel light switch to the OFF
position.
2. Water Temperature Lamp - Indicates that the water
temperature is outside of normal range and will shut
down the engine.
3. Oil Pressure Lamp - Indicates that the oil pressure is
too low or high and will shut down the engine.
4. Fuel Filter Water Level Alarm Lamp - This lamp turns
on when the water level in the fuel filter rises too high.
Drain the water in the fuel filter strainer to correct the
problem.
5. Oil Pressure Gauge – Normal operation should be
approximately 28~71 psi (193~490 kPa). When starting
the generator the oil pressure may read a bit higher, but
after the engine warms up the oil pressure should return
to normal.
6. Water Temperature Gauge – During normal operation this
gauge should read between 165°~203° F. (74°~95° C).
Figure 7. Engine Operating Panel
7. Charging Ammeter Gauge – Indicates the current
being supplied by the engine’s alternator which provides
current for generator’s control circuits and battery
charging system.
8. Fuel Gauge - Indicates amount of diesel fuel available.
9. Tachometer – Indicates engine speed in RPM’s for
60 Hz operation. This meter should indicate 1800 RPM’s
when the rated load is applied. In addition a built in hour
meter will record the number of operational hours that
the generator has been in use.
10. Ignition Switch – Four position switch, pre-heat, stop,
run and start. Insert ignition key to start and stop engine.
11. Pre-Heat Lamp - Indicates (ON) when the engine is
ready for starting during cold weather operating
conditiions.
12. Fuel Leak Detected Alarm Lamp - This lamp will
illuminate when a leak in the fuel containment enclosure
is detected.
13. Panel Light Switch- When activated, will turn on control
panel light.