Filter
Top Products
PAGE 39 — DCA-25SSIU — PARTS AND OPERATION MANUAL (STD) — REV. #7 (04/18/12)
Lubrication Oil
Fill the engine crankcase with lubricating oil through the filler
hole, but do not overfill. Make sure the generator is level.
With the dipstick inserted all the way, verify that the oil level
is maintained between the two notches (Figure 31) on the
dipstick. See Table 10 for proper selection of engine oil. Use
only CC grade or higher.
DCA-25SSIU — PRE-SETUP
Figure 31. Engine Oil Dipstick
When checking the engine oil, be sure to check if the oil is
clean and viscous. If the oil is not clean, drain the oil by
removing the oil drain plug, and refill with the specified amount
of oil as outlined in the Isuzu Engine Operator’s Manual.
liOrotoMdednemmoceR.01elbaT
erutarepmeTtneibmA
egnaR
liOepyT
03-
o
0~
o
22-(C
o
23~
o
)F03-W01EASroW01EAS
0
o
52~
o
23(C
o
77~
o
)F04-W02,W04-w51EASro03EAS
52evobA
o
68(C
o
)F04EAS
Fuel
Fill the fuel tank with clean and fresh
diesel fuel
. DO NOT
fill the tank beyond capacity.
Pay attention to the fuel tank capacity when replenishing
fuel. Refer to the fuel tank capacity listed on page 19
Specification Table 5.
The fuel tank cap must be closed tightly after filling. Handle
fuel in a safety container. If the container does not have a
spout, use a funnel. Wipe up any spilled fuel immediately.
CAUTION :CAUTION :
CAUTION :CAUTION :
CAUTION :
Never fill the fuel tank while the engine is
running or in the dark. Gasoline spillage
on a hot engine can cause a fire or
explosion. If gasoline spillage occurs, wipe
up the spilled gasoline completely to
prevent fire hazards.
Coolant
Use only drinkable tap water. If hard water or water with
many impurities is used, the inside of the engine and radiator
may become coated with deposits and cooling efficiency
will be reduced. See maintenance section on page 42 and
43 on instructions to flush out radiator.
An anticorrosion additive added to the water will help prevent
deposits and corrosion in the cooling system.