PAGE 31 — DCA-25SSI — PARTS AND OPERATION MANUAL—FINAL COPY(06/29/01)
esUelcatpeceR.6elbaT
esUnirewoP
elcatpeceR
rewoP
elbaliavA
V084/042
esahP-3
V021/042
esahPelgniS
kcoLtsiwTro
9636SC
AMENxelpuD
V021R02-5
524.410
8.022.312.1
7.61214.2
5.218.016.3
4.86.98.4
Receptacle Use
When the UVWO terminals are providing power, the
receptacle power available decrease. Do not exceed
receptacle power available listed on Table 8.
How To Read The Output Terminal Gauges
The gauges (Figures 13 and 15) and change-over switches
on the control panel DO NOT effect the generator output.
They are to help observe how much power is being
supplied produced at the UVWO legs.
When the voltage selector switch is in the 240/120V
position (see Figure 11), place the AC voltmeter change-
over switch to the W-U position (Figure 12) and the AC
ammeter change-over switch to the U or W position (Figure
14) to read the output on the selected leg.
Figure 11. Voltage Selector Switch 240/120V
Single Phase Position
Figure 12. AC Voltmeter
Change-over switch
(Reading the W-U leg on
the output terminal panel)
Figure 15. AC Ammeter
(Amp reading on U lug)
Figure 14. AC Ammeter
Change-over Switch
(Reading the U leg on the
output terminal panel)
Figure 13. AC Voltmeter
Gauge
(Volt reading on W-U Lug)
When using plural single phase
voltages, make sure to balance
the load on each of the single
phase legs.
NOTE
DCA-25SSI — OUTPUT AMPERAGE SETUP