Filter
Top Products
PAGE 30 — DCA-25SSI — PARTS AND OPERATION MANUAL— FINAL COPY (06/29/01)
elbaliavAegatloV.6elbaT
esahP3
)elbahctiwS(
TLOV802TLOV022TLOV042TLOV614TLOV044TLOV084
esahPelgniS
)elbahctiwS(
TLOV021TLOV721TLOV931TLOV042TLOV452TLOV772
Output Terminal Panel Available Voltages
A wide range of voltages are available to supply load to
many different applications. Voltages may be selected by
using the voltage selector switch and depending how you
hookup your hard wire connection to the generator. To
obtain voltages listed, fine adjustment with the voltage
regulator on the control panel is necessary. See the table
below (Table 6) for a list of available voltages the generator
is able to supply.
CAUTION :
NEVER switch the voltage selector switch
position while the engine is engaged.
Voltage Selector Switch Locking Button
The voltage selector switch has a locking button to protect
the generator and generator load from being switched while
the engine is running. To lock the voltage selector switch,
press in the red button located on the lower part of the
voltage selector switch, and use a pad lock to hold it into
this position.
spmAmumixaM.7elbaT
egatloVdetaRspmAmumixaM
esahPelgniS
tloV021
)eriw4(spma5.55
esahPelgniS
tloV042
)eriw4(spma8.72
esahPeerhT
tloV042
spma06
esahPeerhT
tloV084
spma03
Maximum Amps
The following table show the maximum amps the entire
generator can provide. Do not exceed the maximum amps
listed. (See Table 7)
DCA-25SSI — OUTPUT AMPERAGE SETUP
Over Current Relay
An over current relay is connected to the circuit breaker.
During an over current situation, both the circuit breaker
and the over current relay may trip. If the circuit breaker
can not be reset, the reset button on the over current relay
must be pressed. The over current relay is located inside
the control box.