Multiquip DCA-220SSVU Portable Generator User Manual


 
DCA-220SSVU (50 Hz) — OPERATION AND PARTS MANUAL — REV. #0 (04/18/06) — PAGE 29
1
How to Read the Output Terminal Gauge.
The AC ammeter and AC voltmeter change-over switches
on the control panel DO NOT effect the generator output.
They are provided to help observe how much power is being
supplied, produced at the UVWO terminals lugs.
When the voltage change-over board is jumpered for
3Ø,
240V operation (See Figures 17 and18), place the
AC Volt-
meter Change-Over
Switch
(See Figures 19 and 20) to the
W-U position and the
AC Ammeter Change-Over Switch
(Figure 19) to the U or W position to read the output on the
selected leg.
Figure 16. Voltage Change-Over Board
240V Configuration
Figure 17. AC Voltmeter
Change-Over Switch
Figure 18. AC Voltmeter Gauge
(Volt reading on W-U Lug)
Figure 20. AC Ammeter
(Amp reading on U lug)
Figure 19. AC Ammeter
Change-Over Switch
The
ammeter
gauge will only
show a reading when the
Output Terminal Lugs
are
connected to a load and in use.
NOTE
DCA-220SSVU (50 HZ)— GENERATOR OUTPUTS/ GAUGE READING