PAGE 32 — DCA-220SSJ/SSJU — OPERATION AND PARTS MANUAL — REV. #1 (02/28/14)
COOL
1800 RPM
0
1500
3000
TEMP
ENG RPM
98%
14.2
57 PSI
1000 RPM
LOAD RPM
BATTVOLT
ENG RPM
OIL PRES
Setup 4-Up Display
1. From the single or four engine parameter display touch
the “Menu Button”.
2. The main menu will pop up on the display. Use the “Arrow
Buttons” to scroll through the menu until the “Setup 4-
Up Display” is highlighted.
3. Once the “Setup 4-Up Display” menu item has been
highlighted touch the “Enter Button” to activate the
“Setup 4- Up Display” menu.
4. Touch the “Enter Button” to activate the “Use Defaults”
function. This action will reset the unit to the factory
default.
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONFG
ADJUST BACKLIGHT
SETUP 1-UP DISPLAY
SELECT UNITS
SETUP-4-UP DISPLAY
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONFG
ADJUST BACKLIGHT
SETUP 1-UP DISPLAY
SELECT UNITS
SETUP-4-UP DISPLAY
5. The “Use Defaults” screen will be displayed during the
resetting period then will automatically return to the
“Setup 4- Up Display” menu.
6. Select the “4-Up Custom Setup” from the “4-Up Setup”
menu.
7. The quadrant with the backlit parameter value is the current
selected parameter. Use the “Arrow Buttons” to highlight
the parameter value in the quadrant you wish to place a
new parameter.
8. Touch the “Enter Button” and a list of parameters will appear.
USE DEFAULTS
CUSTOM SETUP
RESTORED TO
DEFAULTS
USE DEFAULTS
CUSTOM SETUP
USE DEFAULTS
CUSTOM SETUP
125°F
COOLTEMP
14.2
57 PSI
1000 RPM
BATTVOLT
ENG RPM
OIL PRES
DCA-220SSJ/SSJU — DIAGNOSTIC DISPLAY