DCA-220SSJ/SSJU — OPERATION AND PARTS MANUAL — REV. #1 (02/28/14) — PAGE 21
1
First Time Start Up
1. When power is first applied to the diagnostic display,
the “Logo” is displayed.
2. The “Wait to Start” message will be displayed for
engines with a pre-startup sequence. Once the “Wait to
Start” message is no longer displayed the operator may
start the engine. Note: Displays only when SAE J1939
message is supported by engine manufacturer.
3. Once the engine has started the single engine parameter
is displayed.
Main Menu Navigation
1. Starting at the single or four engine parameter display,
touch “Menu”.
WAITTO
START
PREHEAT
COOL
1800 RPM
0
1500
3000
TEMP
ENG RPM
COOL
1800 RPM
0
1500
3000
TEMP
ENG RPM
2. The first seven items of the “Main Menu” will be
displayed. Touching the “Arrow Buttons” will scroll through
the menu selection.
3. Touching the right arrow button will scroll down to reveal
the last items of “Main Menu” screen highlighting the
next item down.
4. Touch the Arrows” to scroll to the desired menu item or
touch “Menu” to exit the Main menu and return to the
engine parameter display.
GO TO 1-UP DISPLAY
LANGUAGES
STORED CODES
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
G
ADJUST BACKLIGHT
ADJUST CONTRAST
UTILITIES
98%
14.2
57 PSI
1000 RPM
LOAD RPM
BATTVOLT
ENG RPM
OIL PRES
COOL
1800 RPM
0
1500
3000
TEMP
ENG RPM
98%
14.2
57 PSI
1000 RPM
LOAD RPM
BATTVOLT
ENG RPM
OIL PRES
Selecting a Language
1. Starting at the main menu display use the “Arrows to
scroll to the “Language” menu and once highlighted touch
the “Enter” button.
GO TO 1-UPDISPLAY
G
STORED CODES
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
LANGUAGES
DCA-220SSJ/SSJU — DIAGNOSTIC DISPLAY