Filter
Top Products
RULES FOR SAFE OPERATION
4
• Do not use the unit in the rain. Do not use in or around
water.
• Do not handle the plug or unit with wet hands or standing
on any wet surfaces.
• Do not leave the unit plugged in when not in use, changing
attachments or add-ons, or while being serviced.
WHILE OPERATING
• Keep bystanders, especially children and pets, at least
50 ft (15 m) away.
• Wear safety glasses or goggles that are marked as
meeting ANSI Z87.1 standards, and ear/hearing protection
when operating this unit. Wear a face or dust mask if the
operation is dusty.
• Wear heavy, long pants, boots, gloves and a long sleeve
shirt. Do not wear loose clothing, jewelry, short pants,
sandals or go barefoot. Secure hair above shoulder level.
• Use the unit only in daylight or good artificial light.
• Use the right tool. Only use this tool for the purpose
intended.
• Do not force unit. It will do the job better and with less
likelihood of injury at a rate for which it was designed.
• Do not overreach, take extra care when working on steep
slopes or inclines. Always keep proper footing and
balance.
• Always hold the unit with both hands when operating.
Keep a firm grip on both the front and rear handle or grips.
• Keep hands, face, and feet at a distance from all moving
parts. Do not touch or try to stop the cutting attachment
when it is rotating. Do not operate without guards in place.
• Do not operate the engine faster than the speed needed to
do the job. Do not run the engine at high speed when not
in use.
• Always stop the engine/motor when operation is delayed
or when walking from one location to another.
.• If you strike or become entangled with a foreign object,
stop the engine/motor immediately and check for damage.
Have any damage repaired before attempting further
operations.
• Stop the unit IMMEDIATELY if you feel excessive vibration.
Vibration is a sign of trouble. Inspect thoroughly for loose
nuts, bolts or damage before continuing. Repair or replace
affected parts as necessary.
• Stop and switch the unit to off for maintenance, repair, or
for changing add-ons or other attachments. The unit must
be stopped and the cutting head no longer turning to avoid
injury.
• Use only genuine MTD replacement parts and
accessories for this unit. These are available from
your authorized service dealer. Use of any non MTD
parts or accessories could lead to serious injury to the
user, or damage to the unit, and void your warranty.
MAINTENANCE AND STORAGE
• Allow the unit to cool before storing or transporting. Be
sure to secure the unit while transporting.
• Store the unit in a locked up and dry or high and dry place
to prevent unauthorized use or damage, out of the reach of
children.
• Never douse or squirt the unit with water or any other
liquid. Keep handles dry, clean and free from debris. Clean
unit and labels with a damp sponge. Clean after each use.
• Keep these instructions. Refer to them often and use them
to instruct other users. If you loan someone this unit, also
loan them these instructions.
• Only qualified personnel should perform any repairs
or maintenance procedures that are not described
in this manual.
• Check shear bolts, engine mounting bolts and other bolts
at frequent intervals for proper tightness to be sure the
equipment is in safe working condition.
• Inside a building store the machine away from ignition
sources. Allow the engine to cool before storing in any
enclosure.
• Always refer to the Operator’s Manual instructions for
important details if the unit is to be stored for an extended
period.
• Do not attempt to repair the machine unless you have the
proper tools, and instructions for disassembly and repair of
the machine.
SAVE THESE INSTRUCTIONS