Filter
Top Products
7
OPERATING INSTRUCTIONS
The edger add-on should be installed with the release
button in the primary hole.
Check Flex Shaft Engagement Prior to Using:
1. Start the unit.
2. Briefly engage and release the trigger.
3. Check that add-on is operating.
4. If the add-on is not operating, remove add-on and
repeat steps for installing the add-on.
5. Recheck operation of add-on attachment.
3. Turn the knob clockwise to tighten (Fig. 3).
ASSEMBLING THE COUPLER
The TrimmerPlus® system enables the use of these
optional add-ons.
Blower/Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . BV720r
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r
Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . HS720r
Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . . SS725r
Snow Thrower . . . . . . . . . . . . . . . . . . . . . . . . . . . ST720r
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r
Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .TP720r
Removing the add-on
1. Turn the knob counterclockwise to loosen (Fig. 1).
2. Press and hold the release button (Fig. 1).
3. While firmly holding the upper shaft housing, pull the
lawn edger attachment out of the coupler (Fig. 2).
Installing the add-on
NOTE: To make installing or removing the add-on
easier, place the unit on the ground or on a
work bench.
1. Remove the hanger from the top of the shaft housing.
2. Turn knob counterclockwise to loosen (Fig. 1).
3. While firmly holding the add-on, push it straight into
the coupler (Fig. 2).
Fig. 1
Coupler
Release Button
Guide Recess
Knob
Primary Hole
Upper Shaft
Housing
Coupler
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 1).
Fig. 2
Fig. 3
Knob
Lower Shaft
Housing
Release Button
Knob
ClockwiseCounterclockwise
WARNING: To avoid serious personal injury
and damage to the unit, shut unit off before
removing or installing add-ons.
WARNING: Read and understand operator’s
manual for unit to be used with this add-on
prior to operation.
CAUTION: The add-ons with the coupler
system are to be used in the primary hole
only. Using the wrong hole could lead to
personal injury or damage to the unit.
CAUTION: Lock the release button in the
primary hole (Fig. 2) and securely tighten the
knob before operating this unit.