Filter
Top Products
If you receive your unit assembled, check each step to
insure y
our unit is properly assembled. Follow all safety
information in the manual and on the unit.
ASSEMBLY
1.
Assemble three parts into unit. (Fig. 1)
2. Take out assembly screw bolts, washers, nuts from
parts pack and lock into the unit holes (the correspond
location are as Fig. 2)
3. First of all, put the nut in the hole, then support the nut
with your finger and put plug the bolt and washer in
from other side and tighter. (Fig. 3)
DEBRIS SHIELD INSTALLATION
Assemb
le shield as shown (Fig. 4). Keep hands and fingers
away from the sharp blade.Twist shield in direction of arrow
to assemble.
8
7
ASSEMBLY INSTRUCTIONS
Fig. 1
Arrows
Fig. 2
Fig. 4
CONNECT THE CORD
1.
Ensure the cord is NOT plugged into a receptacle
before this procedure.
2. Make a loop with 8” - 10” (20 - 25cm) of the end of the
extension cord.
3. Place the loop into the groove at the end of the rear
handle and lock into place as shown in Fig. 5.
4. Connect the extension cord to the plug on the trimmer.
5. Plug the extension cord into a receptacle ONLY when
you are ready to operate the trimmer.
STARTING
1. When starting the string trimmer for the first time, check
that the nylon lines touch or pass over the line-cutting
blade. If they are not long enough, press the button
and, at the same time, pull the nylon lines (Fig. 6).
2. Connect the plug of the string-trimmer to the extension
cord and attach this to the handle. (Fig. 5)
3. Take a secure hold of the grass trimmer. Without letting
the trimmer touch the grass, press the switch (A) on the
upper handgrip (Fig. 7). Let the string trimmer run for a
few seconds and “bump” the string head against the
lawn. Nylon line will automatically release. The cut-off
knif
e in the debr
is shield will tr
im off e
xcess line
.
4.
T
o s
witch off the string trimmer let go of the switch.
These oper
ations should be repeated a f
e
w times bef
ore
starting work to make sure that everything is functioning
properly and to familiarize yourself with the string trimmer.
Start off slowly, when you have gained experience, you will
be able to use the grass trimmer to its full potential.
OPERATING INSTRUCTIONS
Fig. 5
Fig. 3
Fig. 6
A shor
t or w
or
n line
cuts less efficiently
so, to improve its operation on subsequent
occasions
, tap the spool b
utton lightly on the
ground while the trimmer is running. This will
bring about the self-adjustment of the nylon
line
.
(Fig. 8)
CAUTION:
Fig. 7
A
Fig. 8
BUMP