Filter
Top Products
5
SECTION 4: CONTENTS OF HARDWARE PACK
Lay out the hardware according to the illustration for identification purposes. Part numbers are shown in
parentheses. (Hardware pack may contain extra items which are not used on your unit.)
NOTE: The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. If you hit a hard foreign
object or an ice jam, the snow thrower is designed so that the bolts may shear. Two replacement shear bolts and
nuts are provided for your convenience. Store in a safe place until needed.
IMPORTANT: NEVER replace the auger shear bolts with standard hex bolts. Any damage to the auger gearbox or
other components as a result of doing so will NOT be covered by your snow thrower’s warranty.
A
ATTACHING THE HANDLES
Hex Bolts
(710-3180)
Hex Bolts
(710-3008)
Lock Washers
(736-0119)
Carriage Bolts
(710-0262)
Cupped Washers
(736-0242)
B
ATTACHING THE CHUTE ASSEMBLY
Hex Bolts
(710-3015)
Chute Flange
(731-0851A)
Keepers
Hex Lock Nuts
ATTACHING THE CHUTE CRANK
C
Hair Pin Clip
(714-0104)
Hex Nut
(712-3010)
5/16-18 x 1-3/4”
5/16-18 x 3/4”
5/16” I.D.
5/16” I.D.
1/4-20 x 3/4”
1/4”-20
(712-3027)
5/16”-18
ATTACHING THE SHIFT ROD
AND CONTROL CABLES
Ferrule
(711-0677)
3/8” I.D. x 5/8” O.D.
Flat Washers
(736-0275)
Hair Pin Clip
(714-0104)
AUGER SHEAR BOLTS (SPARES)
Shear Bolts
(710-0890A)
(712-0429)
Hex Lock Nuts
5/16”-18
5/16-18 x 1-1/2”
Cupped Washers
(736-0242)
5/16” I.D.
5/16”-18
Hex Nuts
(712-3010)
Saddles
(784-5599)
Flat Washers
(736-0185)
3/8” I.D. x 5/8” O.D.
D
E
F
Controls
(746-0950)
Track
ATTACHING THE TRACK CONTROLS
Hex Bolts
(710-3103)
5/16-18 x 2”
Spacers
(750-1032)
5/16”-18
Hex Lock Nuts
(712-0429)
“Z”-Fitting
(746-0778)
Jam Nuts
#10-24 Thread
(712-0121)
AND CLUTCH GRIPS