MTD E665E Snow Blower User Manual


 
6
SECTION 5: ASSEMBLY INSTRUCTIONS
IMPORTANT:
After assembly, service engine
with gasoline, and check oil level as instructed in
the separate engine manual packed with your unit.
NOTE:
References to right or left side of the snow
thrower are determined from behind the unit in the
operating position.
UNPACKING
• Remove staples or break glue on the top
flaps of the carton. Remove any loose parts
included with unit (i.e., operator’s manual,
etc.).
Cut along dotted lines and lay end of carton
down flat. Remove packing material.
Roll unit out of carton. Check carton
thoroughly for loose parts before discarding.
TOOLS REQUIRED FOR ASSEMBLY
(1) 3/8" or adjustable wrench
(2) 7/16" or adjustable wrench
(2) 1/2" or adjustable wrench
LOOSE PARTS IN CARTON
(See Figure 1)
Figure 1
A (2) Handles (Right and Left)
B (1) Handle Panel Assembly
C (1) Speed Selector Plate
D (1) Shift Lever
E (1) Chute Crank Assembly
F (1) Chute Assembly
(1) Hardware Pack
A
C
D
E
F
B