Filter
Top Products
14
NOTE: If you placed plastic under the gas cap, be
certain to remove it.
AUGER CLUTCH ADJUSTMENT
To adjust the auger clutch, refer to Final Assembly
and Adjustments section on page 9.
CARBURETOR ADJUSTMENT
WARNING: If any adjustments are
made to the engine while the engine is
running (e.g. carburetor), keep clear of all
moving parts. Be careful of heated
surfaces and muffler.
Minor carburetor adjustment may be required to
compensate for differences in fuel, temperature,
altitude and load.
Refer to the separate engine manual packed with
your unit for carburetor adjustment information.
DRIVE WHEELS
The wheels may be adjusted for two different
methods of operation. The adjustment is made by
placing the klick pins in one of two different holes on
the right side of the unit. See Figure 19.
1. One Wheel Driving—On the right side of the
unit, place klick pin in the outside axle hole only.
Do not place pin through wheel hub. This
position gives power drive to the left wheel only,
making the unit easier to maneuver.
2. Both Wheels Driving—Rotate wheel assembly
to align hole in hub with inner hole on axle
shaft. Insert klick pin in hole. Outer axle shaft
hole should be visible. See Figure 19.
Figure 19
SECTION 9: LUBRICATION
WARNING: Disconnect the spark
plug wire and ground against the
engine before performing any repairs
or maintenance.
ENGINE
Refer to engine manual for engine lubrication
instructions.
WARNING: When following instruct-
ions in separate engine manual for
draining oil, be sure to protect frame to
avoid oil dripping onto transmission
parts.
WHEELS
Oil or spray lubricant into bearings at wheels at
least once a season. Pull klick pin, remove wheels,
clean and coat axles with a multipurpose
automotive grease. See Figure 20.
Figure 20
CHUTE CRANK
The worm gear on the chute direction crank should
be greased with multipurpose automotive grease.
AUGER SHAFT
Remove shear bolts on auger shaft. Oil or spray
lubricant inside shaft. See Figure 21.
Figure 21
GEAR SHAFT
Lubricate the gear shaft with a good all-weather
multi-purpose light grease at least once a season or
after every 25 hours of operation.
IMPORTANT: Keep all grease and oil off of the
friction wheel and drive plate.
Outside
Hole in Axle
Klick Pin in Hub
and Inner
Axle
Hole
Hole
Oil Bearings
or Spray Lubricant
Axle
Klick
Pin
Shear Bolts
Bearings