Filter
Top Products
7
Figure 5
4. Place the auger control grip on top of the left
handle. The triangular metal tab must be
between the handle and the grip bracket. See
Figure 6.
Figure 6
5. Secure with hex bolt, spacer and lock nut. See
Figure 6. (Do not overtighten this bolt as it will
prevent the grips from automatically returning to
their upright position.)
6. Repeat process for the right side Traction
Control Grip.
7. Lay handle assembly behind snow thrower. See
Figure 7.
Figure 7
8. Insert a hex bolt 3/4” long and lock washer
through the lower hole on the bottom of the
handle. See Figure 7.
9. Hold the handle assembly up to the bottom of
the snow thrower frame and thread the hex bolt
into the lower hole in snow thrower frame. Do
not tighten at this time. See Figure 8.
Figure 8
10. Repeat process on the other side.
11. Raise the handle assembly into the upright
position and align the top holes in the handles
with the top holes in the snow thrower frame.
Attach using hex bolts 1 3/4” Long, lock washers
and saddles. (Curve in saddle must match the
curve in the handle.) See Figure 9.
12. Tighten all hardware used to attach the handle
assembly to the snow thrower frame.
Auger Control
Grip
“Z” Fitting
Triangle
Metal Tab
Auger Control Grip
Left Grip Bracket
Handle
Panel
Hex
Spacer
Hex Lock Nut
“Z” Fitting
Left
Handle
Screw
Triangle
Metal Tab
Hex Bolt
Lock Washer