Filter
Top Products
5
SECTION 4: CONTENTS OF HARDWARE PACK
A
ATTACHING THE HANDLE ASSEMBLY
Lay out the hardware according to the illustration for identification purposes. Parts are illustrated approximately
one-half size. Part numbers are shown in parentheses. (Hardware pack may contain extra items which are not
used on your unit.)
B
ATTACHING THE CHUTE ASSEMBLY
C
ATTACHING THE CHUTE DIRECTIONAL
CONTROL
D
ATTACHING THE SHIFT ROD
AND CLUTCH CABLES
F
AUGER SHEAR BOLTS
Ferrule
(711-0677)
Hairpin Clips
(714-0104)
Hex Nuts
#10-24 Thread
(712-0121)
“Z”-Fitting (R)
(746-0778)
NOTE: The augers are secured to the spiral shaft with two shear bolts and hex
lock nuts. If you hit a hard foreign object or an ice jam, the snow thrower is
designed so that the bolts may shear. Two replacement shear bolts and nuts are
provided for your convenience. Store in a safe place until needed.
E
ATTACHING THE CLUTCH GRIPS
Flat Washers
5/16" I.D. x 5/8" O.D.
(736-0264)
Hex Bolts
5/16-18 x 1-3/4" Long
(710-3180)
Hex Bolts
5/16-18 x 3/4" Long
(710-3008)
Hex Nuts
5/16-18 Thread
(712-3010)
Saddle
(784-5599)
Lock Washers
5/16" I.D.
(736-0119)
Carriage Bolts
5/16-18 x 1-1/2" Long
(710-0262)
Hex Bolts
1/4-20 x 3/4" Long
(710-3015)
Hex Lock Nuts
1/4-20 Thread
(712-3027)
Chute Flange
Keepers
(731-0851A)
Hex Lock Nuts
5/16-18 Thread
(712-0429)
Shear Bolts
5/16-18 x
1-1/2" Long
(710-0890A)
Hex Screw 5/16-18
x 2.0 (710-0116)
Hex Top L-Nut
5/16-18 (712-0429)
Spacer
.325 I.D. x .50 O.D. x .25
(750-1032)
Flat Washers
3/8” I.D. x 5/8” O.D.
(736-0185)
Hairpin Clip
(714-0104)
Cupped Washer
5/16” I.D.
(736-0242)
Hex Nuts
5/16-18 Thread
(712-3010)
Eyebolt Not Shown
(747-0697)