Filter
Top Products
5
SECTION 2: ASSEMBLING YOUR CHIPPER SHREDDER
IMPORTANT: This unit is shipped WITHOUT
GASOLINE or OIL in the engine. Be certain to service
engine with gasoline and oil as instructed in the
separate engine manual before operating your
machine.
NOTE: Reference to right or left hand side of the
chipper shredder is observed from the operating
position.
Removing Unit From Carton
• Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
• Remove loose parts if included with unit (i.e.,
operator’s manual, etc.)
• Cut along corners, lay carton down flat, and remove
packing material.
• Roll or slide unit out of carton and check carton
thoroughly for loose parts.
Loose Parts In Carton (See Figure 1)
• Hopper Assembly
• Discharge Chute
• Chipper Chute (462 thru 465)
• Bag (Not Shown)
• Tamper Plug (If Equipped)
• Safety Glasses (Not Shown)
Disconnecting Spark Plug Wire
Before setting up your chipper shredder, disconnect the
spark plug wire from the spark plug and ground against
the engine.
>12mm
S30186
>76mm
S30039