Filter
Top Products
9
4
WARNING
Never run the engine
indoors or in a poorly
ventilated area. Engine
exhaust contains
carbon monoxide, an
odorless and deadly
gas.
Starting Engine
WARNING: Never run the engine
indoors or in a poorly ventilated area.
Engine exhaust contains carbon monox-
ide, an odorless and deadly gas.
1. Attach spark plug wire to spark plug. Make certain
the metal cap on the end of the spark plug is fastened
securely over the metal tip on the spark plug.
2. Engines with choke lever:
Move choke lever on engine to CHOKE position. (A
warm engine may not require choking).
Engines with primer:
Prime engine as instructed in separate engine manual.
3. The throttle control lever is located on the engine.
Move engine throttle control lever to FAST or START
position. See Figure 10.
4. Grasp starter handle and pull rope out slowly until
engine reaches start of compression cycle (rope will
pull slightly harder at this point).
NOTE: A noise will be heard when finding the start of
the compression cycle. This noise is caused by the flails
and fingers, which are part of the shredding mechanism,
and it should be expected until the impeller reaches full
speed.
5. Pull rope with a rapid, continuous, full arm stroke.
Keep a firm grip on starter handle. Let rope rewind
slowly.
6. Repeat the previous steps until engine fires. When
engine starts, move choke control (if equipped)
gradually to RUN position.
Stopping Engine
1. Move throttle control lever to STOP or OFF position.
2. Disconnect spark plug wire from spark plug and
ground against the engine.
NOTE: See your engine manual packed with your unit for
more detailed instructions.
Using The Chipper Shredder
Yard waste such as leaves and pine needles can be
raked up through the hopper assembly for shredding.
After material has been shredded by the flail blades on
the impeller assembly, it will be discharged out of open-
ing or into catcher bag. Do not attempt to shred or chip
any material other than vegetation found in a normal
yard (i.e. branches, leaves, twigs, etc.) Avoid fibrous
plants such as tomato vines until they are thoroughly
dried out. Twigs and small branches up to 3” in diameter
can be fed into the chipper chute.
Lowering The Hopper Assembly
1. With one hand grasp the handle at the top of the
hopper assembly and lift slightly.
2. With the other hand pull out on the release rod
and lower the hopper assembly to the ground. See
Figure 9.
To Empty Bag
1. Un-clip drawstring and loosen bag from chute
deflector opening.
2. Empty bag and reattach to the discharge chute
opening. Pull on the drawstring until the bag is tight
around the chute opening and clip the drawstring
tight against the chute deflector.
IMPORTANT: The flail screen is located inside the
housing in the discharge area. If the flail screen
becomes clogged, remove and clean as instructed in
SECTION 5: MAINTAINING YOUR CHIPPER SHRED-
DER. For best performance, it is also important to keep
the chipper blade sharp.
Operating
Your Chipper
Shredder
NOTE: A noise will be
heard when finding the start
of the compression cycle.
This noise is caused by
the flails and fingers, which
are part of the shredding
mechanism, and it should
be expected until the impel-
ler reaches full speed.
Figure 10