Filter
Top Products
9
For cultivation, this may be reduced to 13 inches by
removing the outer tines. Refer to the Adjustment
Section. When laying out plant rows, be sure to allow
enough width to permit cultivation between the rows. In
growing corn or similar crops, check-row planting will
permit cross cultivation and practically eliminate hand
hoeing. See Figure 9.
Figure 9
The tiller has many uses other than tilling and
cultivating a garden. One of these is the preparation of
lawn area for seeding. The tiller will prepare a deep
seed bed which will be free of hard untilled spots,
allowing a better stand of grass to grow. The tiller is
very useful for loosening hard soil for excavation with a
shovel. No tedious handwork will be necessary. Your
tiller may be used for mixing compost in the pile, or for
mixing it with the soil in your garden. This should be
done after the soil has been broken to the full working
depth. The compost should be worked in to a depth of
six to seven inches. This may be done by working the
length of the garden and then by making separate
passes across its width. The addition of decayed
organic matter will substantially increase the fertility of
your garden. For proper decaying action, fertilizer
should be applied and worked in with the mulch
materials. Breaking up leaves and straw and mixing it
with several inches of soil causes the soil to hold
moisture longer and allows proper aeration of the plant
root system. This also retards the growth of weeds.
SECTION 5: MAKING ADJUSTMENTS
WARNING: Disconnect the spark plug
wire and ground it against the engine
before performing any adjustments.
Engine Adjustment
Refer to the separate engine manual for engine
adjustment instructions.
Wheel Adjustment
To adjust the wheel yoke and wheel position, refer to
the Operating Section.
Depth Stake Adjustment
To adjust the depth stake to a desired position, refer to
the Operating Section.
Clutch Control Adjustment
Periodic adjustment of the belt tension may be required
due to normal stretch and wear on the belt. To adjust
the clutch control lever, refer to the Assembly Section.
Tine Width Adjustment
The tilling width of the unit is 22 inches. Tilling width can
be increased to 24 inches by removing the clevis pins
and hairpin clips, sliding the outer tines out one inch,
and securing in this position with the clevis pins and
hairpin clips. For cultivation, reduce the tine width to 13
inches by removing the outer tines completely.
See Figure 10.
Figure 10
22”
24”
13”