Filter
Top Products
8
Step 3. Replace the hardware removed from the
lower handle. Tighten all four handle
(two on each side of the handle
assembly) nuts with 1/2" wrench or
socket.
Step 4. Raise the complete handle assembly
until it lines up with one of the mounting
holes in the struts. Put the carriage bolt
through the struts and then through the
handle. Place the saddle washer on the
bolt and then fasten with the wing nut by
hand. Complete this step by attaching
the other side of the handle to the other
strut
Note: Use the same height hole in each strut. Height holes in each strut allow for
handle height adjustment up and down.
Remove
Pivot