Filter
Top Products
10
SECTION 4: CONTROLS
Figure 2
BLADE CONTROL BAIL
For units equipped with Engine Brake Control:
The blade control bail is located on the handle of the
mower. See Figure 2. The blade control bail must be depressed in order to start and operate the unit.
Release the blade control bail to stop the engine and blade.
For units equipped with Blade Brake Control:
Squeeze the upper bail to the handle, then push the lever
forward to engage blade. Figure 2
WARNING:
The blade control is a safety device. Never attempt to bypass its operations. On
engine brake control models the blade will rotate whenever the engine is running.
DRIVE CLUTCH CONTROL (IF EQUIPPED).
Squeeze the drive clutch control against the upper handle to engage drive. Release the drive clutch control to
slow down and stop. Use the clutch to slow down when negotiating an obstacle or making a turn. DO NOT SLIP
OR “FEATHER” THE CLUTCH. See Figure 2.
THROTTLE CONTROL
The throttle control is located on the right side of the upper handle. It is used to regulate the engine speed.
See Figure 2.
• Push the throttle lever forward for fast.
• Pull the throttle lever back for slow.
WARNING:
The throttle control cannot be used to stop the engine, for models with engine brake.
The throttle control must be used to stop the engine on blade brake control models.
RECOIL STARTER
The recoil starter handle is attached to the upper handle. See Figure 2. Stand behind the unit in the operating
position to start the unit.
SPEED SHIFT LEVER (IF EQUIPPED)
The three speed shift lever is located on the rear left side of the mower deck. This lever is used to select the
operating speed of the mower. Release the drive clutch control when changing speed. Only change one
speed at a time.
ENGINE BRAKE CONTROL MODEL
Blade Control Bail
Throttle Control
Drive Clutch Control Bail
Recoil Starter
BLADE BRAKE CONTROL MODEL
Blade Brake Control