Filter
Top Products
4
(Usually, the fuse block is the most convenient connecting point. It is also
possible to connect to the Accessory terminal on the fuse block, so that your
CB automatically goes off when the ignition goes off, preventing accidental
battery drainage.)
The orange wire supplies power for the memory retention feature. For the
memory retention circuit to operate the orange wire must be connected to
power that is not switched off by the ignition switch. The connection point
can be directly to the battery or an unswitched fuse on the fuse block.
(Usually , the fuse block is the most convenient connecting point. It is also
possible to connect the red wire to the Accessory terminal on the fuse block
or ignition switch wo that your CB automatically goes off when the ignition
goes off, preventing a battery drain.)
Note: In many new vehicles the only circuit that has noise filtering is the
radio circuit.
Then tightly connect the black wire directly to the vehicle’s metal
frame. A good direct metal - to - metal ground is essential for optimum
performance. Installations using the cigarette lighter socket for power
require an extra ground wire from the radio chassis to the vehicle if the radio
is not fastened to a grounded part of the vehicle.
Step 3: Plug - in the power cord to the receptacle provided on the back of the
transceiver.
Mounting the main unit.
Step 1: Position the main unit between the bracket arms in line with the
retention knobs. Set the angle for optimum operating comfort and
accessibility.
Step 2: Tighten the retention knobs.
Installation of microphone hanger.
Mounting holes are provided on the microphone hanger bracket. The
bracket can be attached to the vehicle dash, or other convenient location.
Antenna: How to select, position install