Filter
Top Products
12
HOW TO USE THE ANGLE CUT LEVER
FOR A BEVELED EDGE
The index lever has positions that will provide a
beveled edge (15, 0, -15 degrees). A bevel edge cut
along a sidewalk or driveway makes a trench and will
reduce the need to edge as often.
1. Stop the engine and disconnect the spark plug
wire from the spark plug.
2. Loosen the front wheel knob (See Figure 12). Slide
the front wheel all the way to the right side. This
will prevent the blade from hitting the wheel.
3. Securely tighten the front wheel knob.
4. Disengage the angle cut lever (See Figure 13).
Move the angle cut lever to the desired notch
(15, 0 or -15 degrees).
5. Before you start the engine, line up the edger as if
you were going to bevel cut. Move the clutch lever
down to test the blade location. Return the clutch
lever to the “N” NEUTRAL position.
6. Reconnect the spark plug wire to the spark plug.
7. Start the engine.
8. Move the clutch lever to the desired cutting
depth.
OPERATION
Figure 12
Figure 13
Front Wheel Knob
Angle Cut Lever
Front Wheel