Filter
Top Products
7
76 cm
CONFIGURING YOUR UNIT
Youcan configure yourunit usingacuttinghead
for grass and light weeds, or a weed blade for
cutting grass, weeds, and brush up to 1 cm in
diameter. Toassemble your unit, go to the sec-
tion for the desired configuration and follow the
instructions.
ASSEMBLY INFORMATION --
TRIMMER HEAD
TRIMMER
HEAD
NOTE:Removethebladeandmetalshieldbe-
fore attaching the plastic shield and trimmer
head. To remove blade, align hole in the dust
cup withtheholeinthesideofthegearbox by
rotating the blade. Insert a smallscrewdriver
intoalignedholes. This willkeeptheshaft from
turning while loosening the blade nut. Remove
blade nut by turning clockwise. Remove the
screwdriver. Remove both washers and blade.
To remove metalshield,loosen andremovethe
four mounting screws. See ATTACHING THE
METAL SHIELD and INSTALLATION OF THE
METALBLADEforillustrations. Besure tostore
all parts and instructions for future use.
ATTACHING THE PLASTIC SHIELD
AND TRIMMER HEAD
WARNING: Theshield must beprop-
erly installed. The shield provides partial
protection totheoperator andothers fromthe
risk of thrown objects, and is equipped with a
linelimiterblade whichcuts excess line tothe
proper length. The line limiter blade (on un-
derside of shield) is sharp and can cut you.
1. Remove nut from shield.
2. Insert bracket into slot on shield.
3. Pivot shielduntilboltpasses throughhole
in bracket.
4. Reinstall nut and tighten securely with
wrench (provided).
NOTE: If your unit has a plastic cover over
thethreadsonthethreadedshaft,removethe
coveringtoexposethethreads.Beforeinstal-
lingthetrimmerhead,makesurethedust cup
and retaining washer are positioned on the
gearbox as shown below.
Nut
Retaining Washer
Dust Cup
Bracket
Slot
Shield
Gearbox
NOTE: Make sure all parts are properly
installed as shown in the illustration before
installing the trimmer head.
5. Alignholein thedustcupwith theholeinthe
sideof thegearbox by rotatingthedustcup.
6. Insert a small screwdriver into aligned
holes. Thiswillkeeptheshaftfromturning
while tightening trimmer head.
Screwdriver
7. While holding the screwdriver in position,
thread trimmer head onto the shaft in the
direction shown on the decal (counter-
clockwise). Tighten until secure.
NOTE: The retaining washer must be posi-
tioned with the raised section facing toward the
gearbox.
ASSEMBLY INFORMATION -- WEED
BLADE
WEED
BLADE