Filter
Top Products
1
2
1
3
38
WARNING!
Themachinemustbestanding
absolutelystillwhentheparkbrake
isengaged.
Visually check that no damage is found on the lever,
linages, or switch belonging to the parking brake.
Perform a stand still test and check that there is a
braking action.
To adjust the parking brake, contact the McCulloch
service workshop.
ParkingBrake
WARNING!
Faultyadjustmentcancausean
accident.
DeckBelt
Check every 100 hours of operation. Check for severe
cracking and large nicks.
NOTE: The belt will show some small cracks in
normal operation.
The belts are not adjustable. Replace belts if they
begin to slip from wear.
DeckBeltRemoval
Park on a level surface. Apply parking brake.1.
Lower the deck into the lowest cutting position.2.
Remove bolts from belt shields and remove 3.
shields.
Remove any dirt or grass that may have 4.
accumulated around the cutter housings and
entire deck surface.
Loosen the nut securing the belt guide. Note the 5.
position of the belt guide for reinstallation.
Carefully roll the belt over the top of the cutter 6.
housing pulleys and remove belt from the deck.
8058-080-1
Released parking brake
8058-107
Belt shields1.
Belt guide2.
Idler arm3.
Removing the deck belt