McCulloch 966564101 Lawn Mower User Manual


  Open as PDF
of 60
 

22
BladeSwitch
In order to engage the mower deck, pull the knob out;
the mower blades are disengaged when the knob is
depressed.
8058-019
Cut height lift lever
8058-123
Blade switch
8058-080-1
Released parking brake
IMPORTANTINFORMATION
Inordertoobtainanevencuttingheightitis
importantthattheairpressureinallfourtires
isthesame15psi(1bar).
IMPORTANTINFORMATION
Alwaysusethehighpositiontotransport.
IMPORTANTINFORMATION
Themachinemuststandabsolutelystillwhen
applyingtheparkingbrake.Alwayssetthe
parkingbrakebeforedismounting.Releasethe
parkingbrakebeforemovingthemower.
ParkingBrake
The parking brake is found on the left of the machine.
Push the release button and pull the lever backward
to activate the brake—push forward to release it.
The park brake is designed to hold the mower from
moving and is not intended for use in stopping the
mower while it is in motion. The engine will stop if the
park brake is engaged while the control levers are in
the drive position.
CuttingHeightAdjuster
To set the desired deck cutting height, press the
release button and move the lever forward to the
correct cutting height on the cutting plate. The cutting
height range is from 1½" (38mm) to 4"(102mm) in ½"
(13mm) increments. The heights are measured from
the ground up to the blade tip with the engine not
running.
 previous next