Filter
Top Products
5
How to Use
BLOW
Position 1 - Blow Mode
The Gardenvac will blow debris from patios, paths, driveways,
lawns, bushes, borders etc.
Using As A Blower
1. Select position 1 on the mode indicator. See fig L.
2. Point nozzle towards the ground.
3. To start squeeze trigger.
4. Stand back from debris to be cleared.
5. Point nozzle towards the debris and slowly approach.
6. To stop release trigger.
VACUUM
JET VACUUM
WARNING
The use of eye protection is recommended. The use of ear protection is recommended.
To prevent dust irritation, the wearing of a face-mask is recommended. Never point your product at
bystanders. Do not use your product in the rain. Do not leave your product outdoors while it is raining.
IMPOR
TANT!: YOUR PRODUCT WILL NOT OPERATE UNTIL THE FULLY ASSEMBLED DEBRIS BAG AND
FRAME ARE PROPERLY FITTED.
BEFORE USE: E
NSURE THERE ARE
NO GAPS
BETWEEN THE DEBRIS BAG AND THE PRODUCT
.
• The Gardenvac has 3 modes of operation.
• These can be selected by moving the mode indicator to adjust the nozzle position for blow, vacuum or jet vacuum
mode.
• In vacuum and jet vacuum modes the product will shred leaves etc.
Position 2 - Vacuum Mode
In this position your product will pick up leaves, paper, rubbish, cans
etc. IMPOR
TANT: R
EMOVE
N
YLON
L
INE
BEFORE V
ACUUMING
C
ANS
Using As A Vacuum
1. Select position 2 on the mode indicator. See fig M.
2. Position nozzle slightly above the debris, squeeze the trigger and
move slowly back and forth.
3. Do not force the nozzle into the debris as this will impair perform-
ance.
4. To stop release the trigger.
Position 3 - Jet Vacuum Mode
This position is intended to be used to collect debris which is damp
or stubborn. It directs a small jet of air towards the ground which
will loosen stubborn material.
Using As A Jet Vacuum
1. Select position 3 on the mode indicator. See fig N.
2. Position the nozzle above and slightly forward of the debris and
squeeze the trigger.
3. Slowly move the nozzle back over the debris. This allows a jet of air
to lift the debris from the ground.
4. To stop release the trigger.
P
✔
✕
Emptying your Gardenvac
• Switch off and disconnect from the mains
electricity supply BEFORE REMOVING OR
REPLACING the fully assembled debris bag.
Emptying Your Gardenvac
1. Remove debris bag as described on page 4.
2. Empty debris bag holding the moulded handle at
the top of the bag and the fabric handle at the
bottom of the bag. (P)
D
O
N
OT
P
LACE
H
ANDS IN
B
AG
W
HEN
E
MPTYING
,
S
HARP
D
EBRIS
C
AN
C
AUSE
I
NJURY
3. Flip the debris fin back into place before re-fit-
ting as described on page 3.
N
M
L