Filter
Top Products
Please enclose a note
describing your problem and
your phone number. If still
under warranty, please
include a copy of your invoice
and date of purchase.
WARNING: Always unplug
your tool before performing
any maintenance or repairs.
Use only identical Master
Appliance brand replacement
parts.
Lubrication
Apply 2-3 drops of SAE 20
non-detergent oil to oil holes
every 6 months.
Typical Applications
(cont’d)
NOTE: Users should independently evaluate the suitability of the product for their application.
Maintenance Instructions
All repairs and maintenance
other than that recommended
in this instruction manual must
be performed by a qualified
repair technician who is expe-
rienced with the repair of elec-
tric tools, a qualified service
organization, or Master
Appliance Corp.’s Service
Department.
For prompt and efficient main-
tenance and repair service,
return your product to:
Master Appliance Corp.
Attn: Repair Department
2420 - 18th Street
Racine, Wl 53403
Cleaning
Unplug heat blower before
cleaning. To clean outside of
tool, use only a mild soap and
damp cloth. Do not use other
cleaning agents, turpentine,
gasoline, lacquer or paint thin-
ner, or other solvents that may
contain chemicals which are
harmful to plastics and other
insulating materials. Never
immerse tool in a liquid or
allow a liquid to enter inside
the tool. Make sure all vents
and openings are free and
clear of debris.
Shrinking Tubing
Use stand to free both hands.
Slide tubing over area to be
insulated. Place in air stream
and move with a side-to-side
motion until tubing has shrunk.
Drying
Drying ink and paint on screen
prints, posters or paper may
be done manually or by
directly mounting the heat
blowers to the processing
equipment.
Shrinking Packaging
Your Masterflow Heat Blower
can be used for a variety of
heat-shrinking applications.
For example, it can be used to
shrink bottle caps manually by
gently waving the nozzle
around the cap until it has
shrunk.
One or two heat blowers may
be permanently mounted to a
conveyor system to shrink
caps as the bottles pass by.
Shrink Tunnel Systems
The Masterflow can be used
on heat-shrink tunnel systems.
It is recommended that the
blower or blowers be mounted
in a horizontal position to pre-
vent overheating of the heat
blower.
If you have any questions
regarding your specific appli-
cation or use, feel free to call
our Sales Department at
(262) 633-7791.
6