Filter
Top Products
11
114716
OWNER’S MANUAL
CLOSED
OPEN
Figure 12 - Engine Switch In ON Position
ENGINE SW
ON
OFF
OPERATION
Continued
Fuel Valve Lever (ON Position)
Choke Lever (Closed Position)
Figure 10 - Fuel Valve Lever On, Choke
Lever Closed (Model MGR4500I Shown)
Note:
If oil level is too low, oil alert system
will keep engine from starting (see Oil Alert
System, page 6). Make sure oil level is full
before starting. See Engine Oil, page 7.
Before starting the engine, disconnect all
electric loads from generator.
STARTING
IMPORTANT:
The engine speed is preset.
The throttle is locked in preset position. Do
not adjust throttle. Preset position lets en-
gine run at 3600 RPM under load. The
engine must maintain 3600 RPM for gen-
erator to create correct voltage. Running
engine at lower speeds will damage genera-
tor and powered items.
IMPORTANT:
Never start generator with
electrical loads connected. Start engine be-
fore adding electrical loads.
1. Make sure gasoline tank is full. See
Fuel, page 7 for fuel information.
2. Move fuel valve lever to the ON posi-
tion except on Model MGR6000I (see
Figure 10).
3. Move choke lever fully to the left for
all models except MGR6000I (see Fig-
ure 10). Pull choke button out for
Model MGR6000I (see Figure 11).
This closes the choke.
Note:
You may not need to close choke
if engine is warm or air temperature is
high.
WARNING: Only responsible
adults should use generator.
Never let anyone operate genera-
tor without proper instructions.
PRESTART
Operate generator on a firm, dry, and clean
surface. The surface must be level. Protect
generator from heavy dust, sand, dirt, rain,
or snow. Do not locate generator near stand-
ing water and snow. Make sure area is well-
vented.
4. Start the engine.
Turn engine switch to the ON position
(see Figure 12). Remove slack from
starter rope by lightly pulling starter
grip. Next, pull starter rope briskly.
IMPORTANT:
Do not let starter grip
snap back against engine. Return it gen-
tly. This will prevent damage to starter.
Note:
If engine does not start, check
the oil in the crankcase. Add oil as nec-
essary. Be sure engine is on a level sur-
face. See Oil Alert System, page 6.
5. As engine warms up, slowly move choke
lever fully to the right (see Figure 13)
(all models except MGR6000I). This
opens the choke. On Model MGR6000I,
slowly push in choke button until fully
depressed (see Figure 14).
Continued
Figure 11 - Choke Lever Closed (Model
MGR6000I Shown)
Choke Lever (Closed Position)
CLOSED
OPEN
Fuel Valve Lever (ON Position)
Choke Lever (Open Position)
Figure 13 - Choke Lever Opened (Model
MGR4500I Shown)
Figure 14 - Choke Lever Opened (Model
MGR6000I Shown)
Choke Lever (Open Position)