Mantis 7252 Tiller User Manual


 
Assembly
WARNING DANGER
IMPROPER ASSEMBLY OF THIS TILLER CAN RESULT IN SERIOUS INJURY.
MAKE SURE TO FOLLOW ALL INSTRUCTIONS CAREFULLY.
Your MANTIS Electric Tiller comes partially
assembled. You must install only the handlebars, the
handle brace, and the tines. This will take just a few
minutes if you follow the directions.
First, take all items out of the carton. But do not
remove the cardboard from around the tiller’s base.
The list below, shows the parts that come with your
tiller. Check to make sure you have them.
The bag of hardware is in the plastic bag containing
the owner’s manual and video.
To assemble your MANTIS Electric Tiller, you’ll
need two 7/16" (11 mm) wrenches. We suggest that
you install all nuts and bolts only “finger tight” —
that is, one-half to one full turn — until you’ve
completed assembly. The nuts are self locking, but
you must use a wrench to tighten them completely.
Qty. Description *Key no.
1 Upper handle assembly 7
1 Upper handle trigger assembly 1
2 Lower handles 10
1 Pair tiller/cultivator Tines 54/55
1 Motor assembly (includes fender
guard, worm gear transmission
& complete housing) 62**
1 Handle brace 14
1 Bag of hardware containing:
2 Round head square neck bolts 16
4 Lock nuts 17
2 Bolts (7.6 cm long) 20
2 Tine retaining pins 53
2 Handle clamps 19
2 Bolts (2.5 cm long) 13
2 Knobs 12
2 Cable clamp 18
*These numbers are the same numbers shown on the parts layout on
pages 16 and 17.
**This key no. is for assembly purposes only.
12
20
13
16
18
53
17
19
62
54, 55
14
1
7
10
A. Parts
Electric tiller
5