Makita UML2OOD Trimmer User Manual


 
Installing or removing battery cartridge
0
Always switch off the tool before insertion or removal of the battery cartridge.
.To remove the battery cartridge, pull out
the
set
plate on the bottom of the tool
and grasp both sides of the cartridge
while withdrawing
it
from the barrel.
.To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip
it
into
place. Snap the
set
plate back into place.
Be sure to close the
set
plate fully before
using the tool.
0
Do
not use force when inserting the battery cartridge.
If the cartridge does not slide in easily,
it
is
not being inserted correctly.
Charging
.Plug the
fast
charger into your power
source. Insert the battery cartridge
so
that the plus and minus terminals on the
battery cartridge are on the same sides
as
their respective markings on the fast
charger. insert cartridge fully into the
port
so
that
it
rests on the charger port
floor.
Fig.
1
CAUTION
:
.Your new battery cartridge
is
not charged. You will need to charge
it
before use.
0
If you try to charge
a
cartridge from
a
just-operated tool, sometimes the charging light
will not come on after you insert
a
cartridge from
a
just operated tool.
Let
the cartridge
cool off for
a
while. Then re-insert
it
and try to charge
it
once more.
0
If you wish to charge two battery cartridges, allow
15
minutes between chargings on the
fast charger.
6