Filter
Top Products
22
(1) HOW TO USE IDLE CONTROL
Start the engine with IDLE CONTROL
SWITCH off.
NOTE :
Warm up the engine without a load for a
few minutes.
Turn IDLE CONTROL SWITCH on.
(2) CHECKING THE OPERATION
When IDLE CONTROL does not operate normally, please check following :
Overloaded ?
Please make it sure that the generator is not overload.
NOTE :
Most induction loads such as electric motors require three to five times more
wattage than their ratings during starting.
This starting wattage should not exceed the rated output of the generator for proper
operation of IDLE CONTROL.
Turn IDLE CONTROL SWITCH off when the IDLE CONTROL does not work
normally under the rated output.
NOTE :
The IDLE CONTROL may not operate when the applied load is under 40W. In such
cases turn the IDLE CONTROL SWITCH off.
(3) STOPPING THE ENGINE
Turn off the switch of load.
Switch off generator's AC breaker.
Disconnect tool or appliance.
Turn the IDLE CONTROL SWITCH off.
Turn the STOP SWITCH to the position "O" (OFF).
NOTE :
Allow the engine about 3 minutes to cool down at no-load before stopping.
IDLE CONTROL (Except G2800R)
IDLE CONTROL automatically reduces engine speed when load is OFF, and auto-
matically increases engine speed to rated r.p.m. when load is ON.
IDLE CONTROL provides fuel economy and low noise operation at no-load run-
ning.
ON OFF