Filter
Top Products
LIMITED WARRANTY
on Emission Control Systems
-
California Only
-
MAKITA , a distributor of small off-road equipment in the U.S., warrants to the owner of 2005
and later engines that the engine (1) has been designed, built, and equipped at the time of man-
ufacture so as to conform with the applicable regulations of the California Air Resources Board
and, (2) is free from defects in materials and workmanship which may cause it to fail to conform
with those regulations as applicable according to the terms and conditions stated below.
WARRANTY PERIOD
This warranty period begins on the date which the engine is delivered to the original retail pur-
chaser and ends two years after that date. During this two year period MAKITA warrants to the
original retail purchaser and each subsequent purchaser that the engine is free from defect in
material and workmanship that can cause the failure of a warranted emission-related part.
WHAT IS COVERED UNDER THIS WARRANTY
Repair and/or replacement of any warranted emission-related part will be performed at no
charge provided the work is performed at an authorized warranty station. There will also be no
charge for any diagnostic labor performed at an authorized warranty station which leads to the
determination that a warranted emission-related part is defective.
Any warranted part which is not scheduled for replacement as required maintenance, or which is
scheduled only for regular inspection to the effect of "repair or replace as necessary" shall be
warranted for the warranty period. Any warranted part which is scheduled for replacement as
required maintenance shall be warranted for the period of time up to the first scheduled replace-
ment of that part. This warranty shall apply only towards the repair, replacement, and/or adjust-
ment of the component parts listed below.
EMISSION-RELATED PARTS COVERED UNDER THIS WARRANTY
(1) Fuel Metering System
(i) Carburetor and internal parts (and/or pressure regulator or fuel injection system).
(ii) Air/fuel ratio feedback and control system, if applicable.
(iii) Cold start enrichment system, if applicable.
(iv) Regulator assy (gaseous fuel, if applicable)
(2) Air Induction System
(i)Intake manifold, if applicable
(ii)Air filter.
(3) Ignition System
(i)Spark plugs.
(ii)Magneto or electronic ignition system.
(iii)Spark advance/retard system, if applicable.
(4) Exhaust manifold, if applicable
(5) Miscellaneous Items Used in Above Systems
(i)Electronic controls, if applicable
(ii)Hoses, belts, connectors, and assemblies.
(iii) Filter lock assy (gaseous fuel, if applicable)