Makita EM4341 Trimmer User Manual


 
22
0.7mm-0.8mm
(0.028-0.032)
CLEANING OF AIR CLEANER
DANGER: INFLAMMABLES STRICTLY PROHIBITED
Interval of Cleaning and Inspection: Daily (every 10 operating hours)
Turn the choke lever to the full close side, and keep the carburetor off from
dust or dirt.
Remove the air cleaner cover-fixing bolts.
Pull the cover lower side and detach the air cleaner cover.
If oil adheres to the element (sponge), squeeze it firmly.
For heavy contamination:
1) Remove the element (sponge), immerse it in warm water or in water-diluted
neutral detergent, and dry it completely.
2) Clean the element (felt) with gasoline, and dry it completely.
Before attaching the element, be sure to dry it completely. Insufficient drying
of the element may lead to difficult startup.
Wipe out with waste cloth, oil adhering around the air cleaner cover and plate
breather.
Immediately after cleaning is finished, attach the cleaner cover and tighten it
with fixing bolts. (In remounting, first place the upper claw, and then the lower
claw.)
Points in Handling Air Cleaner Element
Clean the element several times a day, if excessive dust adheres to it.
If operation continues with the element remaining not cleared of oil, oil in
the air cleaner may fall outside, resulting in oil contamination.
CHECKING THE SPARK PLUG
Only use the supplied universal wrench to remove or to install the spark plug.
The gap between the two electrodes of the spark plug should be 0.7-0.8mm
(0.028-0.032). If the gap is too wide or too narrow, adjust it. If the spark
plug is clogged with carton or fouled, clean it thoroubhly or replace it.
CAUTION: Never touch the spark plug connector while the engine is running
(danger of high voltage electric shock).
SUPPLY OF GREASE TO GEAR CASE
Supply grease (Shell Alvania 2 or equivalent) to the gear case through the
grease hole every 30 hours. (Genuine MAKITA grease may be purchased
from your MAKITA dealer.)
Gear case
Grease hole
Plate
Breather Part
Fixing bolt
Air cleaner cover
Element (sponge)
Element (felt)
Pick this part and remove the element (felt).