Makita EM4341 Trimmer User Manual


 
10
For EM4341
Fit the handle edge to the handle holder groove, and provisionally fix the
upper side (3) of the handle holder by four bolts M5 x 25 (4).
Adjust the handle to an angle easy to manipulate, and tighten the bolt (4)
uniformly on the right and left sides.
Note: Handle mounting position.
Pass the control cable (6) through the rear grip (7) and insert tube (8) in the
control cable (6).
Fix the control cable to the handle and shaft by two clamps.
Note: If the control cable is not tight, it may be caught by a twig, leading to an
accident.
Lay out the control cable as indicated in the figure.
Note: If the control cable is not tight, it may be caught by a twig, leading to an
accident.
(4)
(3)
to engine
(6)
(8)
(7)