Filter
Top Products
9
MOUNTING OF HANDLE
CAUTION: Before doing any work on the brush cutter, always stop the
engine and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the brush cutter only after having assembled it completely.
For machines with U Handle models
–Insert the handle bar into the handle holder, making sure that the boss in the
handle holder fits into the hole in the handle.
–After the handle bar is in place, tighten the four bolts (M5 x 25).
NOTE: Be sue the bolts are tight, but do not overtighten.
–Fit the control cable (together with the earth cord) to the handle with two
clips (3).
–Avoid any tendency of the control cable to loop at the handle bar.
For machines with Loop Handle models
–Fix a barrier to the left side of the machine together with the handle for
operator's protection.
–Do not adjust position of the loop handle too close to the control grip. Keep
not less than 25cm distance between the handle and the grip.
(a distance collar is provided for this purpose.)
to engine
(3)
to engine