Filter
Top Products
27
Extract from the spare parts list
Use only original MAKITA parts. For repairs and
replacement of other parts, see your MAKITA service centre.
EK6100
EK6101
Pos. MAKITA-No. Qty. Denomination
Synthetic resin cutting disc
1 966 121 150 1 Cutting disc for steel, dia. 300/20 mm
966 141 150 1 Cutting disc for steel, dia. 350/20 mm
966 144 150 1 Cutting disc for steel, dia. 350/25,4 mm
1 966 121 120 1 Cutting disc for masonry, dia. 300/20 mm
966 141 120 1 Cutting disc for masonry, dia. 350/20 mm
966 144 120 1 Cutting disc for masonry, dia. 350/25,4 mm
Diamond cutting disc
22 966 244 632 1 Cutting disc for masonry, dia. 350/25,4 mm
3 994 290 250 1 Hex screw M8x25
4 965 300 501 1 V-belt (EK6100)
965 300 510 1 V-belt (EK6101)
5 963 601 122 1 Suction head
6 315 114 350 1 Tank cap, compl. (fuel)
8 315 173 020 1 Inner Þ lter
9 315 173 010 1 Air Þ lter insert (paper cartridge)
10 395 405 000 1 Disk 5
11 965 603 021 1 Spark plug
12 395 164 010 1 Starter cable ø 3,8x1000 mm
13 181 164 010 1 Starter grip
14 181 163 050 1 Return spring in housing
15 181 163 080 1 Spring
16 181 163 090 1 Driver
17 941 719 131 1 Universal wrench SW 13/19
18 940 827 000 1 Offset screwdriver T27
19 944 340 001 1 Screwdriver (carburetor)
Accessories (not delivered with the Power Cut)
Diamond cutting disc
22 966 . . . . . . 1 Please consult your MAKITA dealer!
26 957 802 600 1 Pressure water tank, cpl.
- 949 000 035 1 Combined can (for 5l fuel, 2.5l oil)
EU Conformity Declaration
The undersigned, Tomoyasu Kato, as authorized by MAKITA Corporation, declare that the MAKITA machines,
Type: 315
Power Cut EK6100, EK6101
manufactured by MAKITA Corporation, 3-11-8 Sumiyoshi-Cho, Anjo, Aichi, 446-8502 Japan, conforms to the basic safety and health
requirements of the applicable EU Directives:
EU Machinery Directive 2006/42/EG, EU EMC Directive 2004/108/ EG, Outdoor Noise Directive 2000/14/EG.
The most important standards applied to properly meet the requirements of the above EU Directive were: EN 19432, CISPR 12,
EN ISO 14982, DIN EN 61000-4.
The conformity assessment procedure 2000/14/EG was performed per Annex V. The measured noise level (L
wa
) is 114 dB(A).
The guaranteed noise level (L
d
) is 115 dB(A).
The technical documentation is on Þ le at MAKITA International Europe Ltd., Michigan Drive, Tongwell, Milton Keynes, Bucks, MK15
8JD, England.
Anjo, 20.8.2012 for MAKITA Corporation
Tomoyasu Kato
Managing Director