Filter
Top Products
FUELSIREFUELLING
Gasoline
Fuel
and
oil
mirture
Inspect the
fuel
tank and
fill
with clean, fresh
fuel
of the proper mixture to
assure
the longer
life
of the tool.
Use
the following mixed gas.
Gasoline
:
Makita genuine two-stroke engine
oil
=
50
:
1
or
Gasoline
:
Other manufacturer’s two-stroke engine oil
=
25
:
1
recommended
FOR CALIFORNIA REGULATION
:
THIS EQUIPMENT
IS
CERTIFIED TO OPERATE ON GASOLINE
+
TWO-STROKE ENGINE OIL
WHEN MIXING GASOLINE WITH TWO-STROKE ENGINE OIL, USE ONLY GASOLINE WHICH CONTAINS NO ETHANOL
OR
METHANOL
VPES OF ALCOHOL). THIS WILL HELP TO AVOID POSSIBLE DAMAGE TO ENGINE FUEL LINES AND OTHER ENGINE PARTS.
DO NOT MIX GASOLINE AND OIL DIRECTLY
IN
THE FUEL TANK.
50:
1
IMPORTANT:
Failure to follow proper
fuel
mix instructions may cause damage to the engine.
1
GAL
2
GAL
-
The engine
of
the hedge Trimmer
is
a
high-efficiency two-stroke
engine.
It
is
run with
a
mixture
of
fuel
and two-stroke engine
oil.
The
engine
is
designed
for
unleaded regular
fuel
with
a
min. -octane
value
of
91
ROZ.
In
case
no such
fuel
is
available, you can
use
fuel
with
a
higher
octane value. This will not damage the engine, but may cause
poor operating behaviour.
A
similar situation will
arise
from the
use
of leaded
fuel.
To obtain optimum engine operation and to protect your health and
the environment, only unleaded
fuel
should be used!
-
For lubricating the engine use
a
two-stroke engine
oil
(quality
grade:TC-3),
which
is
added
to the
fuel.
The engine
has
been designed for
use
with MAKITA two-stroke
engine
oil
and
a
mixture ratio
of
50:l
only to protect the
environment. In addition,
a
long service
life
and
a
reliable
operation with
a
minumum emission
of
exhaust gases
is
guaranteed. It
is
absolutely essential to observe
a
mixture ratio
of
50:l
(MAKITA 2-stroke engine
oil),
otherwise the
reliable
function
of
the Hedge Trimmer cannot be guaranteed.
2.6
OZ
6.4
OZ
-
The
correct
mixture ratio:
Mix
50
parts gasoline with
1
part MAKITA 2-stroke engine oil
(See
table on the right)
NOTE
For preparing the fuel-oil mixture, first mix the entire
oil
quantity with half
o
the fuel required. In an approved can
which meets
of
exceeds
all
local
code
standards, then add
the remaining
fuel.
Thoroughly shake the mixture
before
filling it into the Hedge
Trimmer’s tank.
It
is
not wise to
add
more engine oil than specified to ensure
safe
operation. It will only result in
a
higher production of
combustion
residues
which will pollute the environment and
clog the exhaust channel in the cylinder
as
well
as
the
muffler. In addition, the fuel consumption will
rise
and the
performance will decrease.
Handling petroleum products
Utmost
care
is
required when handling
fuel.
Fuel may contain
substances similar to solvents. Refuel either in
a
well ventilated
area
or
outdoors. Do not inhale
fuel
vapors, avoid any contact of
fuel
or
oil with your skin.
Mineral
oil,
fuel, etc., product degrease your skin.
If
skin comes in
contact with these substances repeatedly or
for
an extended period of
time, various skin diseases may result. In addition, allergic reactions
are
known to occur. Eyes can
be
irritated
by
contact with
oil,
fuel
etc.
If
oil,
fuel,
etc., comes into your eyes, immediately wash them with
clear
water.
If
your eyes
are
still irritated,
see
a
doctor immediately!
A
I
Observe the Safety Instructions on page
4
1
8