Filter
Top Products
STARTING THE MACHINE
Move at least
3
meters away from the place
of
refuelling.
Place
the
Hedge Trimmer on
a
clean area
of
ground make sure that the cutting
tool does not come into contact with the ground or any other objects.
Cold starting (When the engine
is
cold
or
it has been stopped
for
more than
5
minutes or when fuel
is
added
to
the engine.
1.
Push the STOP switch
(1)
to
"I"
position.
2.
Squeeze first the
lock
lever
A
and then the throttle lever
B.
(fig.1)
3.
Keeping the throttle lever
B
depressed, then press the throttle
lock
C
inward.
(fig.
2)
4.
Keeping throttle lock C depressed,
release
the throttle lever
B.
this will lock the throttle lever
B
in position. (fig.
3)
5.
Give
a
gentle push on the primer pump
(2)
repeatedly
(7
to
10
times) until fuel comes into the primer pump.
6.
Move the choke lever
(3)
to position(1-1).
7.
Hold the unit down firmly
so
you will not
lose
control
while cranking
the
engine.
If
not held down properly,
the engine could pull you
off
balance
or
swing the
cutting blade
into
an obstruction or your body.
8.
Slowly pull the starter grip until resistance
is
felt and
continue
with
smart pull until initial ignition are heard.
9.
Depress the
choke
lever
(3)
to the position
(I
+
I)
and
pull the starter
rope
again until the engine
starts.
10.
As
soon
as
the engine starts, immidiately tap and
release the throttle, thus releasing the half-throttle
rock
so
that the engine can run in idle.
11.
Run the engine for approximately one minute at
a
moderate speed before aplying full speed.
EH450 EH620
I
EH450
,
a/
STOPPING THE MACHINE
1. Release the throttle lever completely.
2.
Push the
1-0
switch (on/off switch)
to
"0"
position, the engine rotation will become
low
and the engine will stop.
(fig.
1)
s
(fig.
2)
@
(fig.
3)
Hot staring:
(Restarting immediately after the engine has stopped)
When restarting
a
hot engine, first try the above procedure:
1,
5,7,8.
If
the engine does not start, repeat above steps
1-11.
Note:
Do
not pull the
starter
rope
to its
full
extent and
do
not
allow the starter grip to
be
retracted without control,
ensure
that it
is
retracted slowly.
Gl
in