Makita DCS 6400 Chainsaw User Manual


 
Starting
the
engine
Start the chain saw only after having assembled it com-
pletely and inspected.
Move at least
10
feet (3m) away from the place where you
fuelled the saw.
Make sure you have a good footing, and place the saw on the
ground in such a way that the chain is not touching anything.
Engage the chain brake (lock).
Hold the tubular handle tightly with one hand and press the
chain saw to the ground.
Steady the rear handle by standing in the hand guard.
Cold-starting:
Pull the choke (1) out until it audibly clicks. This simultaneously
actuates the half-throttle lock.
Move the
l/STOP
ignition switch
(3)
as shown by the arrow.
Slowly pull out the starter cable until you notice resistance (the
piston is positioned before the top dead centre).
Push the starting valve
(2)
(option).
Now pull the starter cable with a fast and forceful movement
until you hear the first ignition.
CAUTION:
Do
not pull out the starter cable more than approx.
50 cm, and lead it back by hand.
Push the starting valve
(2)
(option).
Depress the choke (1) and pull the starter cable again.
As
soon
as the engine
is
running, grasp the rear handle (this actuates
the grip safety
(5))
and tap the throttle
(6).
This will release the
half-throttle lock and the engine will run in idle.
CAUTION:
As
soon as the engine is started it must be put
in idle to prevent the chain brake from being damaged.
Now release the chain brake.
Warm
starting:
As
described for cold starting, except before starting pull the
choke (1) all the way out and back in one time, in order to
activate the half-throttle lock.
Stopping the engine
Move the
I/STOP
ignition switch to
the "STOP" position.
6
5
I
BI
Checking the chain brake
Do
not work with the chain saw without first checking the
A
@
@
chain brake1
Start the engine as described (make sure you have a good
footing, and place the chain saw on the ground in such a way
that the guide bar is free of contact).
e
grip
Grasp the tubular handle my with one hand and hold thi
with the other.
With the engine running at moderate speed, press the hand
guard
(7)
in the direction of the arrow with the back of
your hand until the chain brake engages. The chain should stop
Immediately release the throttle and release the chain brake.
IMPORTANT:
If
the chain does not stop immediately when
you test the chain brake, do
NOT
use the chain saw. Take
*
24