Filter
Top Products
9
For # BCM2600 and # BCM3300
Fix the protector (1) to the clamp (3) with two bolts.
For # BCM2310/CA, BCM2610/CA and BCM3310/CA
Fix the protector (1) to the clamp (3) with two bolts.
MOUNTING OF CUTTER BLADE OR NYLON CUTTER HEAD
Turn the Brush Cutter/String Trimmer upside down and replace the cutter blade or the nylon cutting head.
- Installing Cutter-Blade
Mount the cutter blade (A) onto the receiver washer (B).
Make sure that the cutter blade (A) is centered and lies flat.
The guide of the receiver washer (B) must fit in the arbor hole in the cutter blade (A).
Install the clamp washer (C) with the raised center away from the cutter blade (A).
Insert the holding-pin (D) through the slot of the grass cover (E) and rotate the receiver washer (B) until it is locked
with the holding -pin (D). Then install the nut guard (F) and the blade nut (G) onto the gear case and turn counter-
clockwise to tighten securely.
Note : Always wear gloves when handling the cutter blade
- Installing Nylon cutting head
Install the receiver washer (A) onto the gear case.
Insert the holding-pin (B) through the slot of the grass cover (C) and rotate the receiver washer (A) until it is locked
with the holding-pin (B). Then place the nylon-cutting head (D) on the receiver washer (A) and rotate the nylon-cut-
ting head (D) counterclockwise to tighten securely.
(1)
(3)
(3)
(1)
STOP